Macard Wireless WiFi extenders help you get rid of the dead zones and enhance the Wi-Fi coverage within your home. This guide will help you setup your Macard WiFi extender, login to its web interface, and troubleshoot common issues.
Setting Up Your Macard WiFi Extender
- Unpack the Macard WiFi Extender firstly, then plug it to the power socket situated close to your router.
- Make sure to have the extender powered on. The LED sign would be on.
Using WPS (Wi-Fi Protected Setup) Method:
- Press the WPS button on your modem.
- Within two minutes, press the button marked “WPS” located on your Macard WiFi Extender.
- Make sure that the extender is linked to the router. The LED light should solid show, that means a succesful connection.
Manual Method:
- From you computer or on your mobile phone, go to the WiFi settings and search for the network with name “Macard_EXT“.
- In your browser, type in the default IP address (which is most commonly 192.168.10.1 and it may also be in the user manual) or http://go.macard.online.
- Choose your existing Wi-Fi network from the on-screen prompts and enter password, so you will be connected to the network.
- The extender will begin working for you and connect to your network.
Login to Macard WiFi Extender
- Open a web browser.
- In the address bar, write the default IP address of your MAC extender, and then hit enter. This is typically 192.168.10.1 or go.macard.online. Additionally, you can use the manual of the product to obtain the IP address.
- The login page will now come up. Enter the default login information (User name, as well as password are usually both “admin”). Such credentials may also be presented on the extender’s label or user manual
- Click Login. Finally, open the extender’s web interface and then get to the page where you can configure its settings.
Troubleshooting: Why Your Macard WiFi Extender Not Working
Issue 1: No Connection to Router
Solution: Make sure that the extender is placed in the range of your router network. Try resaming the WPS setup or manually connect by written the real WiFi password.
Issue 2: Unable to Login
Solution: Be sure to make a connection with the extender’s network. Verify the IP address and log-in information. This will do the trick if you have already used the old password and forgot it. Just do this: reset the extender to factory settings by holding the reset button for 10 seconds.
Issue 3: Extender Not Connected to Router
Solution: Check to see that your range extender is within a strong signal range of your router. By doing so, one can easily check whether the router is producing the correct level of signal to power the device it is connected to.
Issue 4: Outdated Extender Firmware
Solution: In order to ensure you have the latest firmware update, you should consult Macard website. Place the extender where there are less difficulties and no interruptions.
FAQs
There are two main methods for setting up your extender: We have a Web Interface and WPS. Detailed instructions for both ways can be found in the accompany Macard extender instructions which are also available in the manual.
The most common IP address the Macard repeaters will have when you first access it will be 192.168. l0.1 Nevertheless, you are advised to follow the instruction manual coming with your specific tool.
Then, slide the extender router to the base station, connect it to the same wifi network, and then open a web browser at the default IP address (usually 192.168.l0.1). At the prompt for name/password, you normally enter a username and password (remember to check the device or manual for the default details).
It might be crucial to know why your extender cannot be working. Plug in the extender and router and place them near each other. Ensure you have typed in the right password and enable the WiFi connection.