How To Fix Belkin Router Blinking Red Light?

 Belkin Router Blinking Red Light

  • Make sure that there are no issues with your Internet Service Provider.
  • Try connecting the modem directly to your computer and verify whether you are able to access the Internet.
  • If you are unable to access the Internet, fix issues with the ISP.
  • If you have connected too many devices to the network, remove the unimportant devices connected to the network and try again.
  • Check the Ethernet cable connecting the router and modem and replace it if it is defective.
  • Verify whether you have connected the Ethernet cable from the modem to the WAN port on the router.
  • Unplug the modem and Belkin router from the power source. Wait for at least 10 seconds and reconnect them.
  • If you have connected to the network wirelessly, switch to a wired connection and check if the issue is resolved.
  • You have to connect an Ethernet cable to the LAN port on your Belkin router and the other end of the cable to the modem.
  • If your router’s firmware is outdated, update it.
  • Press the Windows + R buttons to launch the Run dialog box.
  • Type cmd in the Search section and hit the Enter key.
  • Enter ipconfig and press the Enter key.
  • Find the default IP address of the Belkin router in the Default Gateway section.
  • Now, open your web browser and enter the IP address of the router in the address bar.
  • If you have set any settings incorrectly, correct it now.
  • Now, if the router’s light is blinking red again, reset it.
  • You can factory reset the router from the web-based setup page of the router or using the reset button.
  • Locate the red Reset button on the router and press it with a pen for at least five seconds.
  • Once the router is restored to the factory defaults, the belkin router blinking red light issue will be resolved.

Related Articles

Top z