Belkin Router Red Light After Reset

belkin router red light after reset

Proceed with the steps given below to fix the Belkin router red light after reset issue of red light that is lit up on a router after a reset.

  • The red light occurs on the router when there are connection issues.
  • Check all the cable-related issues between the router and the modem.
  • If the cable is physically damaged, replace it with a new one and check the connection.
  • Try connecting the modem directly to your computer using an Ethernet cable and verify your internet connection.
  • If you can’t get an active internet connection, configure the settings of the internet manually.
  • Now, connect the modem and router. Then, connect your router setup to your computer.
  • If the Belkin router red light after reset issue persists, update the router’s firmware to the latest version.
  • Go to the web interface page of the Belkin router to update its firmware.
  • Enter the username and password of the Belkin router, and navigate to the Utilities section.
  • Select Firmware Update and click Check Firmware.
  • If an update is available, continue with the instructions displayed on the screen to perform the update.
  • Restart your router and modem to fix the issue.
  • Power off the modem and the router.
  • Remove the power cable from both the devices and wait for a minute.
  • Now, replug the power cord and turn on the modem, followed by the router. After that, check whether the issue is resolved.
  • Try changing the location of the router.
  • Make sure that you choose a location that is free from devices that emit radio waves.
  • If the red light on the Belkin router doesn’t stop blinking, go to the official Belkin website.
  • Go to the Admin panel and select the LAN settings.
  • If the IP address of the modem starts with 192.168.X.X, replace the address with Then, click the Apply button.
  • When the router is turned, locate the Reset button on the rear side of the Belkin router.
  • Use a pen or paper clip to press the Reset button. Hold it for about 15 seconds.
  • Once the resetting process is complete, your router’s settings will be turned back to the factory defaults.
  • Otherwise, you can go web-based setup page of the router to reset the router.
  • Select the Restore Factory Default option to reset the Belkin router.
  • Once you have completed the above process to solve Belkin router red light after reset, the red light on the router should stop blinking as earlier.

Related Articles

Top z